GeoVision
Back to GeoVision Support | Back up Dwelling house Here are the instructions on how to reset your GeoVision IP camera to factory default settings. Each model of camera has a specific way to do it: VD Series: Unplug the ability cable and the network cablevision. Unscrew the camera'southward top embrace. Press and concord downward the Default button. Power on the photographic camera using a power supply or PoE cable, go along to agree down the Default button for 35 seconds. Allow photographic camera xxx seconds to boot up. FD Series: Unplug the power cable and the network cable. Unscrew the camera'due south acme comprehend. Printing and hold down the Default button. Power on the camera using a power supply or PoE cablevision, continue to concur downwards the Default button for 35 seconds. Allow photographic camera 30 seconds to boot upwardly. GV-FE110/ 420/ 520 Unplug the power cablevision and the network cablevision. Remove the cover by unscrewing three screws indicated below.
Press and concord down the Default button using a precipitous object such every bit a paper clip.
Power on the photographic camera using a power supply or PoE cable, proceed to concord down the Default button. Release the Default button when the network condition LED light turns off. Permit camera xxx seconds to kicking upwards. BL Series: MFD Serial: GV-MFD110 Unplug the PoE cable. Unscrew the camera's top cover. Press and agree the downwards Default button. Power on the photographic camera using the PoE cable. Expect until the network status LED turns off. This volition take about 40 seconds. Release default button. Allow photographic camera thirty seconds to boot up. GV-MFD120 / 130 / 220 / 320 / 520 Unplug the power cable and the network cable. Unscrew the camera'southward top cover. Press and hold the down Default push. Ability on the camera using a power supply or PoE cable. Await until the Link and ACT LEDs turn off. This volition take about 20 seconds. Release default push button. Allow photographic camera 30 seconds to kick up.
BX Series: GV-BX110D Unplug the power cable and the network cable. Printing and hold down the Default push on the back panel of the camera. Power on the camera using a power supply or PoE cable. Wait until the status LED on the front panel of the camera turns off and so turns red over again. This will take nearly 10 seconds. Release default push button. Let camera 30 seconds to boot up. GV-BX120D / 130D Serial / 220D Series / 320D Series / 520D-0 Unplug the power cable and the network cablevision. Press and hold downwards the Default button on the back panel of the camera. Power on the photographic camera using a power supply or PoE cablevision. Wait until the status LED on the front panel of the photographic camera turns on then off twice. This will take virtually thirty seconds. Release default button. Allow camera 30 seconds to boot upwards. |
Source: https://www.worldeyecam.com/ip-camera-factory-reset-instructions.html
Posted by: halpinhounch39.blogspot.com
0 Response to "How To Reset Geovision Ip Camera"
Post a Comment